Table of Contents
Advertisement
Front panel reset — DXP 44, 84, and 88 PLUS
To reset the switcher to the factory firmware version on the DXP 44, 84, and 88 PLUS:
1. Disconnect power from the DXP PLUS, then immediately reconnect it. All front panel LEDs blink four times,
then turn off, leaving the I/O LEDs lit red.
2. Immediately press and hold the I/O button while the front panel LEDs do the following:
a. The Input Signal and HDCP LEDs blink in order in a clockwise, circling pattern.
b. All front panel LEDs blink three times, then turn off.
c. The I/O Video LED lights green.
Disconnect and reconnect power to the switcher.
All front panel LEDs blink four times, then
turn off. The Video and Audio LEDs light red.
Press and hold the I/O button and continue to
hold it until only the I/O Video LED is lit green.
Release the I/O button.
Figure 82. System Reset via Front Panel Buttons
3. When only the Video LED is lit steadily green, release the I/O button.
Resetting Using the Front or Rear Panel Reset Button
The recessed Reset button is on the front panel of the DXP 42 PLUS (see
rear panel of the DXP 44, 84, 88, 168, and 1616 PLUS (see
initiates various levels of soft resets, which restore various tiers of switcher settings to their defaults. For different
reset levels, press and hold the button while the switcher is running or press and hold the button while you apply
power to the switcher. Use a pointed stylus, ballpoint pen, or small screwdriver to press the button. The
next page provides a summary of the reset modes.
ATTENTION:
•
Review the reset modes in the
result in unintended loss of flash memory programming, port reassignment, or a switcher reboot.
•
Analysez minutieusement les différents modes de réinitialisation voir
Appliquer le mauvais mode de réinitialisation peut causer une perte inattendue de la programmation
de la mémoire flash, une reconfiguration des ports ou une réinitialisation du sélecteur.
Power
VIDEO
I/O
AUDIO
VIDEO
I/O
AUDIO
table on the next page
figure 14,
figure 4
or
figure
5,
D
carefully. Using the wrong reset mode could
tableau page
DXP HD 4K PLUS Series • Operation
on page 19), and on the
I
starting on page 9). It
table
on the
suivante.
50
Advertisement
Table of Contents
