Extron electronics DXP HD 4K PLUS User Manual page 59

NOTES:
•
The reset modes listed in the table on the next page close all open IP and Telnet connections and all
sockets.
•
The modes described in the table are separate functions, not a continuation from mode 1 to mode 5.
•
There is no reset mode 2 for DXP HD 4K PLUS Series. If you attempt to initiate it, the Power and Reset
LED blinks 3 times but no reset is performed.
Type Activation
Use Using an Extron Tweeker or other small
Factory screwdriver, press and hold in the
Firmware
recessed Reset button for 30 seconds
while applying power to the switcher.
NOTE: After a factory firmware
reset, update the device with
the latest firmware version. DO
NOT operate with the firmware
version that results from this
mode reset. This temporarily
resets the device to factory
default until power is recycled.
To use factory default firmware,
re-upload that version.
Network
Press and hold down the Reset button
Settings until the Reset LED blinks two times (at
Reset
6 seconds). Then, press Reset
momentarily (less than 1 second).
Full Press and hold down the Reset button
Factory
until the Power LED blinks three times
Reset (approximately 9 seconds). Then,
press Reset momentarily (less than 1
second).
NOTES:
•
For resetting network settings or a full factory reset: Nothing happens if the momentary press does
not occur within 1 second of pressing the Reset button.
•
The factory configured passwords for all accounts on this device have been set to the device serial
number. In the event of a complete system reset, the passwords convert to the default, which is no
password.
Reset Mode Summary
Purpose and Results
The device reverts to the factory default firmware.
Use to revert to the factory default version if
incompatibility issues arise with user-loaded
firmware.
Firmware reverts to the factory default for a
power cycle
.
All user files and settings (drivers, audio and video
adjustments, IP settings, and so on) are maintained.
NOTE: If you do not want to update the firmware
or perform this reset by mistake, cycle power
to the device to return to the firmware version
running prior to the reset.
IP settings revert to factory defaults.
Use to reset all IP settings back to factory defaults:
Port mapping reverts to factory default.
DHCP turns off.
IP address is set to 192.168.254.254.
The Reset LED blinks four times in quick succession
during reset.
The device reverts to the factory defaults except for
firmware.
Use to restart with the default configuration.
All user modifiable configurations reset to default
values including IP settings and real-time
adjustments.
All user loaded files are deleted.
DHCP turns off.
Port mapping reverts to factory default.
The Reset LED blinks four times in quick succession
during the reset.
The initial serial number password is removed and
set to no password.
SIS Command
Equivalent
(None)
single
E 1ZQQQ }
E ZQQQ }
(Absolute system
reset)
DXP HD 4K PLUS Series • Operation 51