Table of Contents
Advertisement
TCP/IP Panel
The TCP/IP panel connects PCS to a specific device through Ethernet. To access this panel, click the TCP/IP tab
to the left of the Device Discovery panel (see figure 97,
Figure 97.
TCP/IP Panel
To connect directly to a connected device with a known IP address:
1. In the IP Address/Hostname field of the Target Device panel (
device.
2. If required, enter the device password in the Password field.
NOTES:
•
The factory-configured passwords for all accounts on this device are initially set to the device serial
number. Passwords are case-sensitive.
•
Performing a unit factory reset (entering an
via the rear panel Reset button) removes the serial number passwords, leaving the unit with no
password.
3. In the Port field (
4. Click the Connect button (
To connect indirectly to a device through a control processor via an AV LAN:
If your DXP PLUS is connected to an AV LAN, you can connect to it through a control processor such as an
Extron IPCP, as follows:
1. In the IP Address/Hostname field of the
the AV LAN, as well as the port number and the password (if needed).
2. Select the Enable Indirect Connection checkbox (
3. In the IP Address/Hostname field of the IP Link Control Processor with AV LAN panel (
address of the control processor connected to the AV LAN.
4. Enter the password if required.
5. Click Connect (
), enter the port number of the desired device (the default is 23).
4
). A new device tab opens.
5
). The TCP/IP window closes and the device configuration window opens.
5
).
1
2
E
ZQQQ } SIS command
Device panel (
Target
2
).
3
DXP HD 4K PLUS Series • Configuration Software
), enter the IP address of the desired
or a
Full Factory Reset
), enter the IP address of the DXP PLUS on
), enter the IP
4
105
Advertisement
Table of Contents
