Advertisement
How To Remove and Reinstall The Platen
Cut
F~rms
Guide
(Back Position)
Paper Release Lever
126
Removing:
1.
Before removing the platen, be sure that the power
is off and the print head is in the center of the platen.
2.
Remove the continuous forms tractor unit, if in-
stalled. See How to Remove and Replace the Continuous
Forms Tractor Unit in this chapter.
3.
Raise the top cover.
4.
Lift on the paper advance knobs (see photograph under
How to Insert Cut Forms), while pressing down on the
platen release levers.
Reinstalling:
1.
Ensure that the print head is in the center of the platen.
2.
Be sure the paper release lever is pointing to the front
of the machine.
3.
Make sure that the paper deflector tray which fits
under the platen is properly seated with the rubber
rollers extending up through the holes provided.
4.
Holding the platen by the paper advance knobs,
align it and press down gently until it snaps into
place.
5.
Return the Print head to the extreme left oosition.
Advertisement
