TROUBLESHOOTING
TROUBLESHOOTING GUIDELINES – ROTAX E-POWER
1. 12V battery is too low.
A 12V battery charger can be used to charge the battery.
2. Emergency stop switch in OFF position or tether cord cap not installed on the vehicle cut-off switch.
Place the emergency stop switch in the ON position and install the tether cord cap (on cut-off switch).
3. Vehicle temperature and/or system voltage is too low.
Connect the vehicle to an Electrical Vehicle Supply Equipment (EVSE) and let the vehicle charging
system recharge the high and low voltage battery packs.
Contact an authorized BRP snowmobile dealer.
If the high-voltage propulsion battery temperature is below -20° C (-4° F), the system will not charge.
If the vehicle is connected to the EVSE, the heater will activate.
228
ELECTRIC VEHICLE DOES NOT TURN ON