Installing
4.8 Mounting the braking resistor
4.8
Mounting the braking resistor
Mounting position
Risk of burns due to touching hot surfaces
During operation and for a short time after the converter shuts down, the surface of the device
can reach a high temperature. Touching the surface of the converter can cause burns.
• Do not touch the device during operation.
• After shutting down the converter, wait for the device to cool down before touching it.
Clearances to other devices
Figure 4-23
Keep shaded areas free of any devices and components.
Mounting instructions
Mount the resistor on a heat-resistant, level surface with a high thermal conductivity.
62
CAUTION
Minimum clearances for the braking resistor when mounting on the floor or a wall
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
SINAMICS G120C Converters