Table of Contents
Advertisement
VM-3100 List of Algoriyhms
yore
When using the gate function to get special reverb effects, make
setting the gate easier by using longer reverb times. In such
instances, instead of using Low Damp or High Damp to change the
tone, do this with the High Cut frequency settings or through
equalization at an earlier stage. To get sharp gate reverb, make the
attack and release times extremely short, and set expression time to
match the rhythm with the hold time setting. To get reverse reverb,
sufficiently lengthen the attack time, and keep the release time
short.
02 EZ DELAY
This is a simple digital delay featuring high-quality sound.
You can set length of the delay to get long echoes or fat, thick
sounds. This algorithm is normally used with the send/
return method.
Filter
Delay (ST)
Gate
Delay
Filter
(MONO, ALT)
Gate
FILTER
These filters allow you to greatly affect the frequency
characteristics of the input sound. There are four types from
which to select.
Type [Type] (Filter Type)LPF, BPF, HPF, NOTCH
This sets the type of filter used.
LPF (Low pass filter)
This filter passes frequencies below the cutoff frequency.
BPF (Band pass filter)
This filter passes frequencies near the cutoff frequency.
HPF (High pass filter)
This filter passes frequencies above the cutoff frequency.
NOTCH (Notch filter)
This filter passes frequencies other than those near the
cutoff frequency.
Level
3}
NOTCH
Slope(oct) [Slope]-12, -24 dB
This sets the filter's slope characteristics at the cutoff
frequency (-24 dB at one octave: steep; -12 dB at one octave:
shallow).
CutOffFfreq [Freq] (Cutoff Frequency)O ~ 100
This sets the filter's cutoff frequency. The closer this is set to
zero, the lower the cutoff frequency; the closer to 100, the
higher the frequency.
Resonance [Reso]O - 100
This sets the filter's resonance level. Raising the setting
increases resonance near the cutoff frequency, giving the
sound a particular characteristic. If the Resonance value is set
too high, another sound (oscillation) begins to appear. Take
care to prevent this sound from damaging your ears or your
playback equipment.
Gain [Gain]O - 24 dB
This compensates for the drop in volume in the cut frequency
range in some filters. The level of correction increases as the
value is increased, raising the volume.
DELAY
This digital delay can be switched between stereo, mono, and
alternate settings. It features a maximum delay of 1200 msec
(1.2 seconds).
Type [Type]ST, MONO, ALT
This switches stereo, monaural or alternate.
MONO (Monaural)
This is a single-input, dual-output delay. Stereo sound is
mixed before being input.
ST (Stereo)
This is a dual-input, dual-output delay. The delay sound
output features the same stereo placement as that of the
12
Advertisement
Table of Contents
