Table of Contents
Advertisement
VM-3100 List of Algoriyhms
OutSP [OutSP] (Output Speaker)
DS-90, MS-50, SST-151, SST-251,
151+351,
2514351
Select the type of speakers that was actually used. When
either "151+351" or "251+351" is selected for "OUT SP," use
parallel connections for chaining two speakers.
DS-90
Roland Powered Monitor DS-90
MS-50
Roland Monitor Speaker MS-50
SST-151
Roland Speaker System SST-151
SST-251
Roland Speaker System SST-251
1514351
Roland Sub Woofer SSW-351 with SST-151
2514351
Roland Sub Woofer SSW-351 with SST-251
Phase [Phase]NORM, INV
Specifies the phase of the speakers.
NRM:
Same phase as the input.
INV:
Opposite phase of the input.
BASS CUT FILTER
This removes unwanted low-frequency components, such as
pop noise.
Frequency [Freq]JTHRU, 20 - 2000 Hz
Adjusts the cutoff frequency of the bass-cut filter.
LOW FREQUENCY TRIM
Gain [Gain]-12 - 12 dB
For low frequency trimmer, adjusts the gain (amount of
boost
/ cut).
Frequency [Freq]20 - 2000 Hz
Set the center frequency of low frequency trimmer.
HIGH FREQUENCY TRIM
Gain [Gain]-12 - 12 dB
For high frequency trimmer, adjusts the gain (amount of
boost / cut).
Frequency [Freq]1.0 - 20.0 kHz
Set the center frequency of high frequency trimmer.
LIMITER
This effect limits excessive output levels.
Threshold [Thr]-60 - 0 dB
Specifies the level at which the limiter will begin to operate.
Release [ReleJO - 100
Adjusts the time from when the input level falls below the
threshold level until the limiter ceases to operate.
Out Level [OutLv]-60 ~ 24 dB
Adjusts the volume level of the sound that has passed
through the limiter.
Copyright
© 1999 ROLAND CORPORATION
All rights reserved. No part of this publication may be
reproduced in any form without the written permission of
ROLAND CORPORATION.
40343823
'99-6-F3-21K
32
Advertisement
Table of Contents
