Roland V-Mixer VM-3100 Owner's Manual page 11

Part Functions
Front I/O Section
1 XLR Input Connectors
These inputs are used for connecting low-impedance
microphones. With mics connected here, compressors
can then be used on Channel 1 or Channel 2.
2 Channel (CH) Input Jacks
Connect mics, guitars, or other sources here.
(MH fr cm fa
Analog signals from CD, MD, and DAT players are input
here in stereo. The gain cannot be adjusted for these
inputs.
This is a special high-impedance jack for use with
guitars. You can plug your guitar directly into this jack
and use the guitar multi-effects. This input is switchable
with Input 4.
3 GAIN Knobs
iy . ne . i, . i, .
Cal aes hala ae Nee Mais aan
'1 - } im fi - be
ENED O NE ey
iad i 3 NC Cyc wm pegs uw: UNEP Aho UNETE) i WC UNET OT uNEraT
These knobs adjust the signal level input to each channel.
4 BUS OUT Jacks
ele;
Connect these outputs to other devices in your studio,
for example the INPUT jacks of a multitrack recorder.
5 AUX SEND Jacks
$ AUXSEND 2
These outputs can be used as effect sends to an external
effects processor or as outputs for a performers monitor
speaker mix.
6 MASTER OUT Jacks
These are the main output jacks. Connect these to the
speakers you use to monitor the Main mix.
7 MONITOR Jack
MONITOR
Connect your headphones here. This functions as the
monitor for each output. Press the DIGITAL IN button
or the SOURCE button to select the output to be
monitored.
11
USING THE UNIT SAFELY
IMPORTANT NOTES. elc.
ie
i
x
a
a
eS
cd =
=
>
oy
Sa Eo
we
~
%
3
V-Mixing Station'?
Trying Out the VM-3100
Digital Mixer Workbook