The DJ-202 includes the following items. Please take a moment to confirm click it. that all of these items have been included with the DJ-202. If you find that Download the manual as directed by the screen. any item is missing, contact the nearest authorized Roland distributor in your country.
[Agree]. When the following screen appears, drag and drop the The DJ-202 USB driver and Serato DJ Intro are not included in the package. [Serato DJ Intro] icon into the Applications folder. Download them from the Roland or Serato website.
Panel Descriptions The top panel of the DJ-202 is divided into three sections by function: browser, deck, and mixer. Phones jack is located on the front side, and input/output jacks are located on the rear side. For details about each part, refer to the DJ-202 owner’s manual and the Serato DJ Intro manual.
Panel Descriptions Deck Section The deck sections located at the left and right control four decks (left: decks 1 and 3, right: decks 2 and 4). Pad Mode select Here you can select the control mode of the performance pads. [HOT CUE] button Selects hot cue mode.
Panel Descriptions Mixer Section This is a four-channel mixer. Here you can adjust the sound, connect sounds, and turn headphone cue on/off. [TRIM] knobs Adjust the volume. [HI], [MID], [LOW] knobs Boost/cut the volume of the high-frequency, mid-frequency, and low- frequency regions.
Panel Descriptions Front Panel [PHONES] jacks Headphones Connect headphones here. Rear Panel (Connecting Your Equipment) Microphone To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections. MIDI device Computer Powered speaker, amp PC port MIC IN jack...
In the [Start] screen or [App View], click the [Serato DJ Intro] icon. Basic Operations in Serato DJ Intro Songs shown in the browser view can be imported into a deck area, and controlled from the DJ-202. Deck section Waveform panel...
Using Serato DJ Intro Playing a Song Monitoring Through Headphones Set the DJ-202’s knobs and switches as follows. Set the DJ-202’s knobs as follows. [MASTER LEVEL] knob Turned all the way to the left [MIXING] knob Turned all the way to the left...
Roland Service Center, Injury could result if someone were to trip on a cable or an authorized Roland distributor, as listed on the Do not repair or replace parts by yourself and cause the unit to fall or topple.
Such noise could occur when receiving or initiating a call, or 5 Roland assumes no liability concerning the restoration of any copyright owner. while conversing. Should you experience such problems, you stored content that has been lost.