Table of Contents
Advertisement
Removal
Fig. 77: Removing centrifugal oil filter cover
1
Rotor base
2
V-clamp
u Unclamp and remove V-clamp 2.
u Open screw on top of cover 3.
u Remove cover 3.
Installation
u Install cover 3 and tighten nut to 13 Nm (10 ft-lb).
u Check seal of V-clamp 2. Replace if necessary.
u Install and tighten V-clamp 2 to 15
5.7.6 Inspecting and replacing centrifugal oil paper filter — SL1-2231,
SL1-2232
Previous tasks
Make sure that the following preconditions are met:
q Preparatory maintenance activities are fulfilled.
p. 100)
q Centrifugal oil filter cover and V-clamp are removed.
centrifugal oil filter cover and cover clamp — SL1-2220, SL1-2221, p. 146)
KD62V12A 33521061401_1_1 EN_US
2023-10
3
Nm (11
ft-lb).
±2
±1
© 2023 by Kohler Co. All rights reserved.
2000 - Lubricating oil system
Cover
(→ 5.4 Preparatory maintenance activities,
(→ 5.7.5 Removing and installing
Maintenance
147
Advertisement
Table of Contents
