Table of Contents
Advertisement
SYSTEM
PARAMETERS
PROGRAMMING
Infinite
4096
H-d
Key Telephone
System
System
Parameters
Programminn
(Cont'dI
710.22
Ia2
ENABLE
Programming
Steps
If this feature
is to be assigned:
a. Press FLASH and dial (231. The following
message
is shown
on the display
phone:
b. The
top
left button
of the flexible
button
field wIU toggle on and oa
l
LED on = yes
l
LEDoff=no
c. Press HOLD
button.
710.23
DISA ACCESS
CODE
Frognrnrning
Steps
If this feature
is to be assigned:
a Press FLASH and dial [24].
'The following
message
is shown
on the display
phone:
b. Enter three digits on the dial pad.
c. Press HOLD
button.
Description
Lf Least Cost Routing
is to be used, it must
be
enabled
here. Before enabling
LCR refer to the
Least Cost Routing
section
and progmmmlng
tables (Appendix
Al. When the tables have all
been programmed.
you may then enable
LCR
for the system.
After system
initialwiuon.
a
default
LCR data base is loaded
into the LCR
section of memory.
Refer to Figure 765-6
for a
listing of the LCR default
database.
Defaulti
By default,
LCR is not enabled
(LED
om.
Related
Pro@
J LCR Programmin&
Nol-E:ProgmmnrIng&estoanyoftheLCR
tables an
onl~~ be pet$omwi
when LCR is dts-
abled.
Description
This
allows
a three
digit access code to be
assigned
to the system.
Anyone
calling
in on
a DISA line must
use the access code in order
to gain access to system features.
Refer to CO line programming
for assignment
of DISA lines.
To disable
the DISA access code, enter
three
(3) pounds
(MM).
Default:
By default
100 fs assigned
as the
access code.
Related
Programmbg
Preset Forward
tier
(Sec. 710.4).
Conferenie
Time-out
Timer
(Sec.
710.7).
CO Une Attributes
(Sec. 720);
DISA
programming.
A
CO I&e(s)
must
be assigned
for DISA operation.
Also see CO Line Privacy
and Conference
options.
710-14
Issue
1, January
1992
Advertisement
Table of Contents
