Table of Contents
Advertisement
Knob
4
5
For details of the method of DME wipe pattern selection, see "DME Wipe
Pattern Selection" (page 412).
Setting the DME wipe pattern size (Size)
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
Press [Size], turning it on.
4
Set the following parameters.
Knob
1
a) The effect size when [Size] is off is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Adjusting the DME wipe pattern cropping
Note
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
1
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
Parameter
Adjustment
Relative H
Relative movement in the
horizontal direction
Relative V
Relative movement in the vertical
direction
Parameter
Adjustment
Size
Set size of effect
Setting values
–400.00 to +400.00
–400.00 to +400.00
Setting values
0.00 to 200.00
Basic Procedure for DME Wipe Settings
a)
419
Advertisement
Table of Contents
