Table of Contents
Advertisement
To return the DME wipe pattern position to the center of the screen
In the <Position> group, press [Center].
Displaying and moving the position of the DME wipe pattern
(position select)
1
2
3
4
Setting relative positions to move the DME wipe pattern
In two-channel mode, use the following procedure.
1
2
3
4
418
Basic Procedure for DME Wipe Settings
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
In the <Position Select> group, the one of the [Top Left], [Top Right],
[Bottom Left], and [Bottom Right] buttons that is on indicates the current
display position of the DME wipe pattern.
In the <Position> group, press [Position], turning it on.
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
In one-channel mode: press [1st Ch], turning it on.
In two-channel mode: from the <Ch Select> group, select the
corresponding channel. You can select more than one channel at the
same time.
To move the position of the DME wipe pattern, press the button where you
want to move to, turning it on.
The DME wipe pattern displayed on the screen moves to the position of
the specified button.
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
In the <Ch Select> group, select the target channels.
Press [Position] in the <Position> group, turning it on.
Set the following parameters.
Advertisement
Table of Contents
