Table of Contents
Advertisement
Saving a wipe snapshot
1
Make the wipe settings that you want to save.
2
In the Flexi Pad control block, hold down the [WIPE] button, and press the
memory recall button corresponding to the register in which you want to
save.
Notes
• If you press a button which is lit orange or yellow, the existing contents
of the register are overwritten.
• If you carry out a pattern mix, and both the main pattern and sub pattern
are selected, then the memory recall button shows the main pattern.
The pattern appears on the button you pressed, which lights yellow.
The numeric display shows the number of the corresponding pattern.
It is also possible to display the register name using a Setup menu (see
"Operation Settings (Operation Menu)" in Chapter 16 (Volume 2)).
WIPE button
Numeric display
XPT HOLD
A B U
U
1 2 3 4
1
2
1
WIPE
3
DME
5
SNAP
SHOT
7
UNDO
Memory recall buttons
UNDO button
Flexi Pad control block (simple type)
2
4
6
8
Wipe Snapshots
407
Advertisement
Table of Contents
