Table of Contents
Advertisement
Recalling a continuous sequence of still images (animation)
You can use a continuous sequence of images captured with the record function
as keyframes to create an effect. By executing this effect you can recall the
continuous sequence (animation).
Notes
• For example, to create an effect using FM1, FM1 must be assigned to a user
region. (For details of user region settings, see "Settings for Switcher
Configuration (Config Menu)" in Chapter 16 (Volume 2).)
• To execute the effect, you must assign the user region to which FM1 is
assigned to a region selection button in the numeric keypad control block.
(For details of assigning to region selection buttons in the numeric keypad
control block, see "Overall Control Panel Settings (Config Menu)" in
Chapter 16 (Volume 2).)
In the Frame Memory menu, effect creation follows the image file names. Of
the eight characters in the file names, if files have the same characters except
for the last three characters they are treated as an image file group, and the
effect is created with the last three (numeric) characters in sequence.
Note
When creating the effect in pair mode (see page 80), the files used must be
main files and sub files with the same last three (numeric) characters in the file
name.
Frame Memory Clip Function
What is a "frame memory clip"?
Movies can be read into frame memory, and recalled and played back. A movie
held in frame memory is called a "frame memory clip."
A frame memory clip can be named using up to four characters. (For details of
frame memory clip names, see "Continuously capturing still images (record)"
(page 83).)
Frame memory clip settings
For frame memory clips, you can make the following settings using a menu or
device control block (trackball/search dial/joystick).
• Start point
• Stop point
• Loop On/Off
84
Frame Memory
Advertisement
Table of Contents
