Selecting Key Fill And Key Source - Sony G363-ZR0-LAX1 User Manual

Selecting Key Fill and Key Source

Selecting key fill and key source

To select key fill and key source for key 1 on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 >Key1 menu, select HF1 'Type.'
The Type menu appears.
2
In the <Key Fill> group, select either of the following for use as key fill.
Key Bus: signal selected on the key 1 fill bus
Matte: signal from the dedicated color matte generator
3
If you selected [Key Bus] in step 2, select the key fill signal on the key 1
row in the cross-point control block.
To select key fill for key 3 or key 4 in the cross-point control block, press
the [KEY3] button or [KEY4] button to the right of the key bus buttons,
turning it on, to allocate the key 1 row or key 2 row to the key 3 fill or key
4 fill, then press the desired cross-point button.
4
If you selected [Matte] in step 2, in the same Type menu, press the [Matte
Adjust] button to display the Matte Adjust menu, then adjust the single-
color or two-color combination color matte. Select whether to use a single-
color matte or a two-color combination in the <Fill Matte> group.
Flat Color: Adjust color 1 with the following parameters.
Knob
1
2
3
Mix Color: Carry out a color mix. Adjust color 1 and color 2, and select a
mix pattern (see the next section).
5
In the <Key Source> group, specify the key source selection mode.
Self: The key fill bus signal is automatically selected as the key source.
When the key type is selected as chroma key, select [Self].
Auto Select: The signal allocated, being paired with the key fill bus signal,
to a cross-point button is automatically selected as the key source. The
setting of key fill and key source pairs is carried out in the Setup menu.
Parameter Adjustment
Luminance Luminance
Saturation Saturation
Hue Hue
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Key Setting Operations Using Menus
347