Table of Contents
Advertisement
Innovative Hearth Products
DRC3000-B Series Direct-Vent Gas Fireplaces
Installing the Backup Batteries
With a battery backup, electronic fireplaces can automatically switch to battery power. In the event of a power outage, this
allows ON/OFF operation (without blower functionality). Install new batteries before every burn season.
1. Access the control compartment, and locate the battery holder.
2. Install four (4) AA batteries in the battery holder.
3. Close the access door.
Continuous Pilot Ignition Switch
Fireplaces with an electronic gas valve have a continuous pilot ignition (CPI) controlled by the switch in the contol
compartment.
This switch allows the pilot to be switched from intermittent mode to continuous mode:
•
Intermittent Mode—The pilot is extinguished when the fireplace is OFF.
•
Continuous Mode—The pilot stays ON when the fireplace is OFF.
In periods of extreme cold, condensation may form on the glass door when the fireplace is OFF and the pilot is in
intermittent mode. Also, with the pilot in intermittent mode, the fireplace may cycle startup (i.e., the pilot and burner ignite,
but the burner extinguishes and reignites several times until the flue reaches the temperature for proper drafting).
•
To save energy—switch to intermittent mode.
•
For a standing pilot that will help prevent glass door condensation and cycle startup—switch to continuous mode.
NOTE: Continuous mode is indicated by a pilot that comes ON and remains lit when the fireplace is OFF.
Operation
901191-00C, 07/2023
61
Advertisement
Table of Contents
