Install The Finishing Materials; Attach The Safety-In-Operation Warnings; Installing Batteries For Backup And Wall Switch - Superior Fireplaces DRT3033TEN-B Installation And Operation Instructions Manual

Innovative Hearth Products
DRT3000 Series Direct-Vent Gas Fireplaces
NOTE: To install the hood after installing the non-combustible finish material over the black surface above the
fireplace opening, the bottom edge of the finish material must be 5/8" above the top edge of the hood to allow
clearance for installation and removal of the hood.
Reinstall the Included Barrier
21.
Reinstall any barrier removed before operating the fireplace. The barrier is designed to
reduce the risk of burns from hot glass. Do not operate the fireplace without the barrier
installed.
NOTE: All models must have a barrier installed prior to operation.
1. Open the control compartment door (Page 52).
2. Hold the barrier in front of the glass door and slide it up into the slots above the glass door and under the hood.
3. Slide the barrier bottom down into the slots below the glass door, securing it in place.

Install the Finishing Materials

22.
1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished wall, position framework to accommodate the thickness
of the finished wall.
Figure 39 - Combustible Wall Framing
Combustible Finished
Non-Combustible Front
Fireboard Standoff
Stand Off Must Be Bent
To Vertical Position
Standoff Provides
Combustible Materials
NOTE: See Cold Climate Insulation on Page 11 and Vent Termination Clearances on Page 13.
Attach the Safety-in-Operation Warning Labels
23.
1. Attach the furnished safety instruction labels at all fireplace operation and control points (Page 46).
NOTE: The installer MUST ensure these warnings are properly attached during installation. The warning labels are a
critical means of informing consumers of safe operation practices.

Installing Batteries for Backup and Wall Switch

24.
1. Locate the battery backup and place four (4) AA batteries in the backup battery holder (Page 39).
2. Locate the wall switch and secure four (4) AA batteries in the wall switch battery holder (Page 39).
NOTE: Replace batteries as a part of standard maintenance (Page 62) and as needed when troubleshooting (Page 69).
This Area
Must Remain
Clear of
Combustible
Materials
1" Min.
(26 mm)
Wall Materials
Space From
4" Clearance
Minimum
Hood
WARNING
Figure 40 - Face Mounting Elements
3"
(77 mm)
Top Of
Appliance
900684-01 06/2018
Top Face Brackets
Fireplace face foot slots
Installation
45