22. Install The Finishing Materials; Attach The Safety-In-Operation Warnings - Superior Fireplaces DRC3000-B Series Installation And Operation Instruction Manual

Innovative Hearth Products
DRC3000-B Series Direct-Vent Gas Fireplaces
3. Remove burner (one screw) and pilot.
4. Remove pan that is inset into floor being careful not
5. Blower access is now possible.
6. Once complete, reassemble unit using the reverse
C. Install Blower
Slide the blower assembly through the front / or side opening to the middle rear area of the cabinet base. Position
the blower assembly so the tabs in the cabinet base are seated in the notches of the blower bracket. Then bend the
tabs over to secure the blower assembly (Figure 48F).
Figure 48F - Blower Installation

22. Install the Finishing Materials

1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished wall, position framework to accommodate the
thickness of the finished wall.
NOTE: See Cold Climate Insulation on Page 11 and Vent Termination Clearances on Page 13.
Figure 48 - Combustible Wall Framing
Stand Off Must Be Bent
Non-combustible Board
Combustible Materials
23. Attach the Satety-in-Operation Warning Labels
1. Attach the furnished safety instruction labels at all fireplace operation and control points (Page 54).
NOTE: The installer MUST ensure these warnings are properly attached during installation. The warning
labels are a critical means of informing consumers of safe operation practices.
to damage gasket.
of the steps above.
FRONT-OPEN DIRECT VENT AND B-VENT GAS FIREPLACE
Combustible Finished
Wall Materials
To Vertical Position
Provides Space From
4" Clearance Minimum
Hood
BLOWER Blower
ELECTRICAL OUTLET
Blower
BLOWER
Mounting
MOUNTING
Tabs
TABS
BLOWER INSTALLATION
This Area Must
Remain Clear
of Combustible
3"
Materials
(77 mm)
1" Min.
(26 mm)
Top Of Appliance
JUNCTION BOX
Junction Box
Electrical Outlet
Installation
901191-00C, 07/2023
53