Table of Contents
Advertisement
Innovative Hearth Products
DRC3000-B Series Direct-Vent Gas Fireplaces
• Turn OFF all gas and electricity to the appliance before installing the embers, and logs.
• Do NOT install the logs until the appliance has been completely installed, the gas line
connected and tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in
incomplete combustion, sooting, and poor flame quality.
• Logs get very hot and remain hot for up to one hour after the gas supply is turned OFF.
Handle the logs only when cool.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable
damage to appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could
occur. This could result in the excessive production of soot and/or the colorless, odorless,
toxic gas carbon monoxide (CO).
Install Accessory Logs,Rock Kit and the Glass Media
16.
1. If accessory logs are desired, the rear panel in the fireplace must be removed to reveal the log placement tabs.
A flat blade screwdriver can assist in the removal of this piece (Figure 36). If no accessory logs are to be installed,
skip to Page 46.
Figure 36
Installing the Accessory Driftwood Log Set
3
6
I.D. No.
1
2
3
WARNING
2
1
Description
I.D. No.
Description
Left Rear Log
4
Right Bottom Log
Rear Log
5
Right Top Log
Left Top Log
6
Front Ember Log
Installation
901191-00C, 07/2023
5
4
43
Advertisement
Table of Contents
