Table of Contents
Advertisement
Air Shutter Adjustment
This appliance has an air shutter control lever located behind the Full
Front Facade, under the glass door (see Figure 20). The lever is linked
to the primary air shutter on the main burner. The air shutter regulates
the amount of primary air the burner receives and therefore how clean
the insert burns. The air shutter should only be adjusted by a qualified
gas technician. The insert should burn for about 15 minutes with the
logs installed before adjusting the air shutter. More air will result in
shorter flames and less color, less air will result in bigger flames and
more color. To adjust the air shutter, slide the adjustment lever side to
side (see Figure 20).
CAUTION: The air shutter should never be set so as to make the
tips of the flames sooty or create sooting on the viewing glass,
logs, or heat exchanger. If soot begins to form after burning,
the air shutter should be opened gradually until the sooting
condition stops. Gas quality and gas pressure may vary, which
can affect the burning characteristics of the insert.
OPEN
Moving shutter adjustment lever to the left will
open shutter, to the right will close shutter.
Shutter Adjustment Detail
Figure 20
CLOSED
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Battery Backup - Battery Installation
This appliance is equipped with a battery backup system. It requires
four (4) "AA" batteries to power the appliance (without the blower) during
a power outage. Install the batteries into the battery holder per instruc-
tions in Figure 21.
Batteries, even if not used, will gradually drain over time. It is rec-
ommended to annually check the batteries for sufficient charge and
replace when necessary.
LEFT SIDE VIEW
Ensure Positive and Negative
ends of the battery are installed
as indicated in battery holder
Figure 21
Battery Holder
+
-
AA Battery
21
Advertisement
Table of Contents
