21. Blower Installation/Replacement - Superior Fireplaces DRC3000-B Series Installation And Operation Instruction Manual

Innovative Hearth Products
DRC3000-B Series Direct-Vent Gas Fireplaces
BARRIER INSTALLATION
Installation (see Figures 47A and 47B)
1. Slide barrier into upper trim panel. NOTE: This panel will rotate for ease of installation.
Figure 47A - Slide Barrier into Upper Trim Panel
2. Lower barrier until it seats into the barrier support bracket. Barrier mesh shall be flush (as seen below) with
Figure 47B - Lower Barrier Until it Seats into the Barrier Support Bracket.

21. Blower Installation/Replacement

NOTE: Follow blower installation instructions (included with blower). See Page 65 for ordering information.
A. If unit is not installed: locate the access panel of left hand side of unit and remove (2 screws) or remove the
B. If unit is installed with optional facade, remove facade and follow Step A. If unit is installed with finishing
52
sticker and spine facing away from fireplace.
Wear cut resistant gloves and protective clothing during this process.
barrier assembly and remove the front lower access panel (2 screws).
material that do not allow for front lower access panel to be removed, follow steps below after unit is completely
cooled.
1. Remove barrier assembly and glass door.
2. Remove all media and perforated glass media tray.
Barrier
Spline
CAUTION
Installation
901191-00C, 07/2023
Barrier
Barrier Support Bracket