Table of Contents
Advertisement
38
Creating Navigation Routes
After specifying the destination point,
press the F2 key (FNL ENT).
5
Enter a name for the route.
To cancel creating a new route, press the F1 key (QUIT).
If the memory is full
When you create a route, the route's data is stored in memory — in the unit's
memory or in the tC card's memory — whichever device you have specified. If the
message "Insufficient memory" appears, this indicates that the device's memory Is
full, which means that you will not be able to save the route until additional memory
is made available. To make more memory available for the route, first check the
unit's memory by choosing System Information from the menu. Then either delete
any unneeded data (points, routes. etc.) from memory, or move data from the unit's
memory to an IC card's memory. To delete data from the unit, see "Deleting Points"
on page 36, "Deleting Routes" on page 40. "Deleting Tracks" on page 52. and
"Releasing Zones" on page 55. For more information on using IC memory cards.
see "Using IC Memory Cards" on page 62.
Getting Started With the Unit
Note:
To enter letters and numbers, refer to
"Entering Letters and Numbers" on page 28.
Note:
When storing data onto an IC memory card.
choose the appropriate card from the
Memory Device option in the System
Setting menu.
Advertisement
Table of Contents
