Table of Contents
Advertisement
Chapter 34 Product Specifications
Table 134 Firmware Specifications
FEATURE
Default IP Address / Subnet
Mask
Default Subnet Mask
Administrator User Name
Default Password
Device Management
SIP Server
Auto Provisioning
QoS
Voicemail
Static Route
Extension Management
Auto-attendant
Outbound Line Groups
LCR
Hunt Group
Page Group
Emergency Call
Conference Calling
284
DESCRIPTION
LAN: 192.168.1.12 / 255.255.255.0
WAN: 172.16.1.1 / 255.255.255.0
255.255.255.0 (24 bits)
admin
1234
Use the web configurator or commands to easily configure the rich range
of features on the X6004.
The X6004 performs SIP proxy, registrar and redirect server functions.
The X6004 can send auto configuration files to ZyXEL IP phones.
The X6004 can mark outgoing VoIP frames with DiffServ code point
values, ToS priority values or user specified values for the ToS field in
the IP header.
The X6004 can store voicemail messages on the flash memory, hard
drive (if installed) or it can forward voicemail messages to individual end
user email accounts.
Maximum voicemail length per message: 90 seconds
Maximum total voicemail length per user: 300 seconds
Static routes tell the X6004 how to forward VoIP traffic to remote
networks.
Manage extensions by placing them in authority groups. You can then
assign calling privileges to the authority groups. The X6004 supports SIP
client devices as well as traditional analog phones if an FXS interface
card has been installed.
The X6004 supports up to 3 sets of auto-attendant profiles to handle
incoming calls. Auto-attendant helps guide incoming calls to their
destination.
Audio Format for Auto-Attendant: G.711 format audio file (*.wav), µ-law
8-bit mono mode.
Maximum size of a single message: 600 kb. Maximum size of all
messages 10 Mb.
The X6004 supports outbound lines via SIP connections to an ITSP,
trusted peer connections. PSTN connections are also supported, if an
FXO interface card is installed.
Least Cost Routing allows administrators to set up dialing rules and
configure priorities for outbound lines used when users make phone
calls.
Configure a group of user extensions which can be reached by dialing a
single phone number. This can be used for a call center application.
Configure sets of extensions that can all be called at the same time by
dialing a single number (page group number). When a page group
number is dialed, all of the extensions automatically pick up via
speakerphone.
Configure emergency telephone numbers which are given the highest
priority for outbound lines on the X6004.
Configure conference rooms which can be accessed by callers from
within your organization as well as from outside your organization.
X6004 User's Guide
Advertisement
Table of Contents
