Table of Contents
Advertisement
the rear cutting unit wear bar and the bumper
stop.
The correct clearance is 0.51 to 2.54 mm (0.02
to 0.10 inch).
5.
Repeat steps
1
through
6.
Lower the cutting units, shut off the engine,
remove the key, and wait for all moving parts
to stop.
7.
Tighten the jam nut.
10
Adjusting Tire Air Pressure
No Parts Required
Procedure
Adjust the tire air pressure at each of the tires; refer to
Checking the Tire Pressure (page
Note:
The tires are over-inflated for shipping.
11
Installing the Hood Latch
CE Machines
Parts needed for this procedure:
1
Lock bracket
2
Rivet
1
Washer
1
Screw (1/4 x 2 inches)
1
Locknut (1/4 inch)
Procedure
1.
Unhook the hood latch from the hood-latch
bracket.
2.
Remove the rivets (2) securing the hood-latch
bracket to the hood
hood-latch bracket from the hood.
4
as needed.
51).
(Figure
30). Remove the
1. Hood-latch bracket
3.
While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood. The lock bracket must be against the
hood
(Figure
nut assembly from the lock bracket arm.
1. CE lock bracket
4.
Align the washers with the holes on the inside of
the hood.
5.
Rivet the brackets and the washers to the hood
(Figure
31).
6.
Hook the latch onto the hood-latch bracket
(Figure
32).
23
Figure 30
2. Rivets
31). Do not remove the bolt and
Figure 31
2. Bolt and nut assembly
g012628
g012629
Advertisement
Table of Contents
