Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (lubricate all
bearings and bushings daily when
conditions are dusty and dirty).
Every 500 hours/Yearly (whichever comes first)
Grease Specification: No. 2 lithium grease
The machine has grease fittings that must be
lubricated regularly. Dusty and dirty operating
conditions could cause dirt to get into the bearings
and bushings, resulting in accelerated wear. Lubricate
the grease fittings immediately after every washing,
regardless of the interval specified.
The grease fitting locations and quantities are as
follows:
•
Rear cutting unit pivot
Figure 57
•
Front cutting unit pivot
Figure 58
•
Steering pivot
(Figure
(Figure
57)
(Figure
58)
59)
•
Rear lift arm pivot and lift cylinder (2)
g008894
•
Left front lift arm pivot and lift cylinder (2)
61)
g008895
•
Right front lift arm pivot and lift cylinder (2)
62)
44
Figure 59
(Figure
Figure 60
Figure 61
g190873
60)
g008898
(Figure
g008899
(Figure