Drive System Maintenance; Checking The Tire Air Pressure; Checking The Torque Of The Wheel Nuts; Checking The Rear-Wheel Alignment - Toro Reelmaster 5010-H Operator's Manual

Figure 108
1. Main power fuse
4. Replace the open fuse with a fuse of the same
type and amperage rating.
5. Assemble the cap to the in-line fuse holder.
6. Close and latch the hood; refer to
Hood (page 49).
Drive System
Maintenance
Checking the Tire Air
Pressure
Service Interval: Before each use or daily
Important:
in all tires to ensure a good quality of cut and
proper machine performance. Do not underinflate
the tires.
1.
2.
3.
g421740
4.
Checking the Torque of the
Wheel Nuts
Service Interval: After the first hour
Closing the
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Maintain the proper torque on the wheel nuts.
1.
2.
Checking the Rear-Wheel
Alignment
Service Interval: Every 800 hours—Check the rear
1.
2.
3.
67
Maintain the recommended pressure
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Measure the tire air pressure.
Note:
The correct air pressure in the tires is 83
to 103 kPa (12 to 15 psi).
If needed add air to or remove air from the tire.
Repeat steps 2 and 3 at the other tires.
After the first 10 hours
Every 250 hours
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Torque the wheel nuts to 94 to 122 N∙m (70 to
90 ft-lb).
wheel toe-in.
Rotate the steering wheel to position the rear
wheels straight ahead.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
At axle height, measure the center-to-center
distance at the front and rear of the steering
tires.
49).
49).
49).