Applying The Ce Decals; Installing The Tipper Roller Kit; (Optional) - Toro Reelmaster 3105-D Operator's Manual

13

Applying the CE Decals

Parts needed for this procedure:
1 CE tilt danger decal (140-7463)
1 Production year decal
1 CE decal
Applying the CE Tilt Danger Decal
1. Wipe clean the steering-arm bracket with
alcohol, and allow the bracket to dry
Figure 35
1. Tilt decal (slope indicator)
2. Remove the backing and apply the CE tilt
danger decal to the bracket
Applying the Year of Production
Decal and CE Decal
1. Wipe clean the left frame near the model/serial
plate with alcohol, and allow the frame to dry
(Figure 36).
Figure 36
1. Model/serial plate
(Figure 35).
g373865
2. Steering-arm bracket
(Figure 35).
g373866
2. Year of production decal
2. Remove the backing and apply the Year of
Production decal to the frame near the serial
plate as shown in
3. Wipe clean the left frame near the hood lock with
alcohol, and allow the frame to dry
1. CE hood latch
4. Remove the backing and apply the CE decal to
the frame as shown in
14
Installing the Tipper Roller
Kit (Optional)
Parts needed for this procedure:
1 Tipper roller kit (not included)
Procedure
When cutting in higher heights of cut, install the Tipper
Roller Kit.
1. Raise the cutting units all the way up.
2. Locate the frame bracket above the center
cutting unit (Figure
3. While pressing down on the front roller of the
center cutting unit, determine which holes on the
tipper bracket align with the frame bracket holes
to attain the same roller contact when the tipper
bracket is installed
25
Figure 36.
(Figure
Figure 37
2. CE decal
Figure 37.
38).
(Figure 38).
37).
g352025