Table of Contents
Advertisement
3.
Secure the steering wheel to the shaft
3) with a jam nut and tighten it to 27 to 35 N∙m
(20 to 26 ft-lb).
4.
Install the cap to the steering wheel and secure
it with a screw
(Figure
3
Charging and Connecting
the Battery
No Parts Required
Procedure
DANGER
Battery electrolyte contains sulfuric acid,
which is lethal if consumed and causes
severe burns.
• Do not drink electrolyte and avoid contact
with skin, eyes, or clothing. Wear safety
glasses and rubber gloves.
• Fill the battery where clean water is always
available for flushing the skin.
1.
Remove the 2 knobs that secure the battery
cover to the machine, and remove the cover
(Figure
4).
1. Knob
2.
Measure the battery voltage.
Note:
If you measure 12.4 V or higher, the
battery is charged.
3.
If you measure 12.3 V or less, charge the battery
at a rate of 3 to 4 A for 4 to 8 hours.
(Figure
3).
Figure 4
2. Battery cover
WARNING
Charging the battery produces gasses
that can explode.
• Keep sparks and flames away from
battery.
• Never smoke near the battery.
4.
When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
5.
Install the positive cable (red) to the positive (+)
battery terminal, and secure them with T-bolt
and nut
(Figure
Note:
Ensure that the positive (+) terminal is all
the way onto the post and the cable is positioned
snug to the battery.
Important:
battery cover.
6.
Install the negative cable (black) to the negative
(–) battery terminal of the battery, and secure
them with T-bolt and nut
WARNING
Incorrect battery cable routing could
damage the tractor and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
g336164
13
5).
The cable must not contact the
(Figure
5).
Advertisement
Table of Contents
