Table of Contents
Advertisement
1. Tipper chain
8
Installing the Cutting Unit
Drive Motors
No Parts Required
Procedure
1.
Position the cutting units in front of the lift arm
pivot rods.
2.
Remove the weight and O-ring
the inside end of the right cutting unit.
1. O-ring
2. Weight
Figure 21
(Figure
Figure 22
3. Mounting bolts
3.
Remove the plug from the bearing housing on
the outside end of the right cutting unit and
install the weights and gasket.
4.
Remove the shipping plug from the bearing
housings on the remaining cutting units.
5.
Insert the O-ring (supplied with the cutting unit)
on the flange of the drive motor
g011218
1. O-ring
6.
Mount the motor to the drive end of the cutting
unit, and secure it with 2 capscrews provided
22) from
with cutting unit
9
Adjusting the Lift Arms
No Parts Required
Checking Lift Arm and Rear
Cutting Unit Clearance
1.
Start the engine.
2.
Raise the cutting units.
3.
At the front cutting units, measure the distance
between the left lift arm and the floor plate
bracket, and the right lift arm and the floor plate
g011964
bracket
Note:
to 5/16 inch). If the clearance is not in this
range, adjust the cutting unit lift cylinder; refer
20
Figure 23
2. Reel motor
(Figure
23).
(Figure
24).
The correct clearance is 5 to 8 mm (3/16
(Figure
23).
g012025
Advertisement
Table of Contents
