Toro Reelmaster 3105-D Operator's Manual page 21

to Adjusting Lift Arm Clearance (page 21)
Adjusting the Lift Arm Stop Bolts (page
Important:
A lack of clearance at the front
plate bracket could damage the lift arms.
Figure 24
1. Lift arm
2. Floor plate bracket
4. At the rear cutting unit, measure the clearance
between the wear strap on the top of the rear
cutting unit wear bar and the bumper stop
(Figure 25).
Note:
The correct clearance is 0.51 to 2.54 mm
(0.02 to 0.10 inch). If the clearance is not in this
range, adjust the cutting unit lift cylinder; refer
to Adjusting the Rear Cutting Unit Clearance
(page 22).
Important:
A lack of clearance at the rear
wear bar could damage the cutting unit.
and
22).
g353279
3. 5 to 8 mm (3/16 to 5/16
inch) gap
1. Bumper strap
2. Wear bar (rear cutting unit)
5. Start the engine, lower the cutting units, shut
off the engine, remove the key, and wait for all
moving parts to stop.
Adjusting Lift Arm Clearance
1. At each side of the machine, loosen the jam nuts
and back off the lift arm-stop bolts
1. Jam nut
2. Loosen the jam nut on the lift-cylinder rod
(Figure 27).
21
Figure 25
3. 0.51 to 2.54 mm (0.02 to
0.10 inch) gap
(Figure
Figure 26
2. Lift arm-stop bolt
g353278
26).
g353221