Table of Contents
Advertisement
1. Carriage bolt (3/8 x 2-1/4
inches)
2. Plate (rear carrier frame)
3. Washer
2.
Align a washer between the carrier plate and
link
(Figure
16), and loosely assemble the plates
and spacer with a carriage bolt (3/8 x 2-1/4
inches), washer, and flange locknut (3/8 inch).
Note:
If you are starting assembly at the back of
the cutting unit, use the middle hole of the plate.
3.
Repeat step
2
at the other plate holes and links.
4.
Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
Assembling the Carrier Frames for
the Front Cutting Units
Cutting Unit with Mounting Plates
Note:
The front carrier frames are part of the optional
lift arm kit.
1.
Align the holes in the plates of the front-carrier
frame with the holes in the cutting unit mounting
plates
(Figure
17).
Figure 16
4. Link (cutting unit)
5. Flange locknut (3/8 inch)
1. Pivot tube (front-carrier
g353110
frame)
2. Carriage bolt (3/8 x 1-1/4
inches)
3. Plate (front carrier frame)
2.
Align a spacer between the carrier plate
and mounting plate
assemble the plates and spacer with a carriage
bolt (3/8 x 1-1/4 inches) and flange locknut (3/8
inch).
Note:
If you are starting assembly at the back
of the cutting unit, use the middle holes of each
plate.
3.
Repeat step
4.
Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
5.
Repeat steps
cutting unit and carrier frame.
Assembling the Cutting Unit and
Rear Carrier Frame
Cutting Unit with Mounting Plates
Note:
The rear carrier frame is part of the optional
lift arm kit.
1.
Align the holes in the plates of the rear-carrier
frame with the holes in the cutting unit mounting
plates
(Figure
18
Figure 17
4. Spacer
5. Mounting plate (cutting
unit)
6. Flange locknut (3/8 inch)
(Figure
17), and loosely
2
at the other plate holes.
1
through
4
for the other front
13).
g353163
Advertisement
Table of Contents
