Mower Manifold - Toro Reelmaster 3105-D Operator's Manual

Note:
The engine shuts off if you press the traction
pedal with the parking brake engaged.

Mower Manifold

The mower manifold is located under the
control-console cover (Figure
Figure 42
1. Backlap control
Reel Speed Knob
Use the reel speed knob of the mower manifold to
adjust the clip rate (reel speed) of the cutting units
(Figure 42).
•
Turn the reel speed knob counterclockwise to
increase the reel speed.
•
Turn the knob clockwise to slow the reel speed.
Refer to Clip Rate (Reel Speed) (page 35)
Adjusting Reel Speed (page 36)
how to adjust the reel speed control.
Backlap Lever
The backlap lever to control the direction the cutting
units rotate when you are mowing or when you
backlap the reels and bedknives
•
Rotate the backlap lever to the F position when
mowing.
•
Rotate the lever to the R position when backlapping
the cutting units.
Important:
Do not change the backlap lever
position while the reels are rotating.
Fuel Gauge
The fuel gauge (Figure
fuel in the tank.
42).
2. Reel speed control
and
for information on
(Figure 42).
43) registers the amount of
1. Seat adjustment lever
g353378
Seat Adjustment Lever
Move the lever
outward, slide the seat to the desired position, and
release the lever to lock the seat into position.
28
Figure 43
2. Fuel gauge
(Figure 43) on the side of the seat
g353382