Controller Options
•
Do not turn ON the write protect switch of the system SD card or application SD card on the machine.
If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a firmware
upgrade or application merge.
1.
Turn OFF the power.
2.
Insert the original SD card in SD card slot 2 (lower). The application program is copied back into this card.
3.
Insert the SD card with the application program in SD card slot 1 (upper). The application program is
copied back from this SD card.
4.
Turn ON the power.
5.
Start the SP mode.
6.
Select SP5-873-002 "Undo Exec."
7.
Follow the messages shown on the operation panel.
8.
Turn OFF the power.
9.
Remove the SD card from SD card slot 2 (lower).
10. Turn ON the power.
11. Check that the application programs run normally.
12. Make sure that the machine can recognize the option (see
section).
PostScript3 Unit Type M28 (D3E6-26, -27, -28)
Accessory Check
No.
1
SD Card (PostScript3 Unit)
2
PS3 Decal
Overview of PostScript3 (Adobe PS)
This machine is equipped with a clone program for emulating Adobe PostScript/PDF (hereafter "Clone PS") as
a standard feature. So, by factory default, it can perform printing using PostScript 3 and PDF Direct Print, in
addition to RPCS.
However, the variety and number of built-in fonts (device fonts) differ between Adobe PS and Clone PS,
sometimes resulting in different printing results.
132
Check All Connections
Description
at the end of this
Q'ty
1
1