Installing The Waste Drain - Hussmann DC-1 Series Installation Manual

PRODUCT INSTALLATION MANUAL
Installing a Waste Drain
Each case must be connected to its own waste drain See Figure 1: service layout for of the drain up-stand. It is
recommended that 40mm DWV (PVC) piping be used.
To install a waste drain:
1. Fit an elbow and pipe to the existing pipe work.
2. Check that the drain is as per Fig (16a).
Fig (16b) Drain trap orientation
3. Use foot mounted brackets or mounting bracket to the case to support PVC drain assembly weight (Refer to Fig
16b).
4. Test for leakage by pouring water down the drain and ensure trap is primed before starting refrigeration.
_________________________________________________________________________________________________________________________
Page 19
NOTES
Drains must be connected as per
stipulated local council requirements.
All joins must be solvent welded.
Fig (16a) Drain trap orientation
CAUTION
Incorrectly installed drain traps will result in
adverse air leaking into the case.
DC13 COLD PLATE
Hussmann