Installing The Internal Perc Card - Dell NX430 Owner's Manual

5. PERC card
7. screw securing the PERC card to the
chassis
4. Remove the screw that secures the PERC card to the chassis.
5. Disconnect the PERC card LED cable from the system board.
6. Hold the PERC card by the edges and pull the PERC card to disengage it from the PERC card slot.
7. Lift the PERC card away from the chassis.
Figure 24. Removing and installing the internal PERC card
1. screw (2)
3. PERC card
5. PERC card LED cable
7. LED cable connector on the system board
Next steps
1. Install the internal PERC card.
2. Install the expansion card riser.
3. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
After working inside your system

Installing the internal PERC card

Prerequisites
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
4. Keep the Phillips #2 screwdriver ready.
6. PERC card slot
2. PERC card lock
4. LED cable connector on the PERC card
6. PERC card connector
89