Table of Contents
Advertisement
1. Select the lock setting option with
2. Press
to validate the selection.
6.2.5.32 Parameters saving
Info
When the last parameter is set and the button
controller updates the database based on the new programming.
The main screen appears and valve status is initializing.
Wait until updating is finished, this may take a few seconds.
6.2.6
Diagnostic
6.2.6.1
Commands
Info
Depending on current settings, some displays cannot be viewed.
If none of the buttons are pushed for 5 minutes in the Diagnostic mode, or if there is a
power failure, the controller returns to Service mode.
1. Press and hold
2. Press
to see the next data group or press
3. Press and hold
6.2.6.2
Flow rate
Info
The display is updated every second.
6.2.6.3
Peak flow rate
Info
The controller registers the highest flow rate since the last regeneration.
Ref. MKT-IM-026 / C - 15.12.2020
and
to enter the Diagnostic mode.
to exit the Diagnostic mode at any time.
Installer manual Fleck 2750 NXT/NXT2 - Programming
;
pressed (after lock settings), the
to return to previous data group.
117 / 170
Advertisement
Table of Contents
