Table of Contents
Advertisement
Installer manual Fleck 2750 NXT/NXT2 - Programming
Info
Lock Window #2 settings are accessible only if lock windows #1 is on.
1. Enable lock window with
2. Press
to validate the selection and advance to the next
parameter.
3. Set lock start time with
4. Press
to validate the selection and advance to the next
parameter;
5. Set lock end time with
6. Press
to validate the selection and advance to the next
parameter.
6.2.5.25 Regeneration cycles time
Set the regeneration cycles duration in minutes.
Info
A maximum of 5 cycles can be programmed.
For filter system only backwash and rapid rinse are available.
The sequence of the regeneration cycles depends upon regenerant flow, see System
regeneration cycle [
110 / 170
and
;
and
;
and
;
→
Page 25].
Lock window #2 activated.
Lock window #2 starts at
13:00.
Lock window #2 ends at
14:00.
Ref. MKT-IM-026 / C - 15.12.2020
Advertisement
Table of Contents
