Pentair FLECK 2750 NXT Installer Manual page 98

Installer manual Fleck 2750 NXT/NXT2 - Programming
Parameter
AUXILIARY 2
ALARM BASED
CYCLE BASED
AUX. 2: CYCLE
BASED
AUX. 2: TIME
BASED - START
TIME #1 duration minus
AUX. 2: TIME
BASED - END
TIME #1 + 1 minute until
AUX. 2: TIME
BASED - START
TIME #2
duration minus
AUX. 2: TIME
BASED - END
TIME #2
+ 1 minute until
98 / 170
Options
STANDBY
OFF
TIME BASED
VOLUME
BASED
SP Service position
BW Backwash position
BD Draw and slow rinse
RR Rapid rinse position
RF Refill position
SB Pause position
0 to total
regeneration
1 minute
from start
time#1
total
regeneration
duration
OFF
End time #1
+ 1 minute to
total
regeneration
1 minute
OFF
From start
time #2
the total
regeneration
duration
Definition
Activates relay from beginning of
regeneration and during standby
phase.
(default) -
- Any alarm or error detected by the
controller will start signal output
from Auxiliary relay#2.
- -
-
- This choice will only available
when metered regeneration type.
Only displayed if "Cycle based" is
chosen for auxiliary 2;
Activate or de-activate for each
position (
position
= activated).
Minute Only displayed if "Time based" is
chosen for auxiliary 2.
Minute
Minute Only displayed if "Time based" is
chosen for auxiliary 2 and END
TIME #1< total regeneration
duration minus 1 minute;
Range depend on Start and end
time #1 values.
Minute Only displayed if "Time based" is
chosen for auxiliary 2 and START
TIME #2 ON;
Range depend on Start and end
time #1 values.
Ref. MKT-IM-026 / C - 15.12.2020
Note
= deactivated;