Table of Contents
Advertisement
Parameter
AUX. 2: VOLUME
BASED –
VOLUME - L
AUX. 2: VOLUME
BASED -
DURATION
PUSH SETTINGS
SAVE AS NON-
FACTORY
LOCK OPTIONS
6.2.5.2
Entering master programming mode
1. Press and hold
enter the master programming mode;
2. Set the password using
ð If the controller calls for a Password that is unknown to
you, please contact your installer.
6.2.5.3
Settings review
Activate or deactivate the settings review mode.
Options:
• on: all parameters and current programming can be displayed but not modified;
• off: all parameters are displayed and programmable.
1. Select the option with
2. Press
to validate the selection and advance to the next
parameter.
Ref. MKT-IM-026 / C - 15.12.2020
Options
0 to MAX
1 to 7200
ON
OFF
ON
OFF
OFF
DELAYED
ENTER CODE
TIME BASED
and
simultaneously for two seconds to
,
and ;
and
.
Installer manual Fleck 2750 NXT/NXT2 - Programming
Definition
Litre
Only displayed if "volume based" is
chosen for auxiliary 1;
Volume range depend on capacity;
Even if maximum theoretical
programmable value is 999999 the
controller will take the unit
capacity as maximum volume.
Second
Only displayed if "volume based" is
chosen for auxiliary 2;
Even if maximum theoretical
programmable value is 9999 the
controller will take 7200 as
duration.
(default)
Only displayed for multi units
system.
-
-
Master programming is saved as
non-factory default.
(default)
-
(default)
Lock setting prevents unexpected
access to master programming.
-
-
-
Note
If lock settings enter code is
activated.
99 / 170
Advertisement
Table of Contents
