Table of Contents
Advertisement
6.2.2
Commands
6.2.2.1
Menu commands
Info
At all menus, press
Menus are displayed in a defined and incremental order.
Editable digit is marked by two triangles (Cursor).
If none of the buttons are pushed for 5 minutes in the Programming or Diagnostic
mode, or if there is a power failure, the controller returns to Service mode without
saving.
Mandatory
In order to store the new settings in the programming mode, it is necessary to go
through all the parameters !
1. Press
to pass to the next step and temporary save current parameter changes.
2. Use
to move the cursor to the next digit, or use
3. Use
and
4. Press
at any time to return to previous step without saving the current parameter changes.
6.2.2.2
Access commands
1. Hold pressed 2 seconds the following buttons.
Ref. MKT-IM-026 / C - 15.12.2020
to return to previous screen without saving.
to adjust the values.
• Enter diagnostic menu
• Enter time of day menu
• Enter time of day menu
• Initiate an immediate regeneration
• Access to user programming menu
• Access to master programming menu
Installer manual Fleck 2750 NXT/NXT2 - Programming
to move the cursor to the previous digit.
87 / 170
Advertisement
Table of Contents
