Wireless Kit (Rcn-T-5Aw-E2) - Mitsubishi Heavy Industries V Multi FDC71VNX Technical Manual

4.1 WIRELESS KIT (RCN-T-5AW-E2)

5.1 WIRELESS KIT (RCN-T-5AW-E2)
Notes:
Following function of FDT indoor unit series are not able to be set with this wireless remote control
(RCN-T-5AW-E2).
1. Individual flap control system
Safety precautions
●Please read this manual carefully before starting installation work to install the unit properly.
Every one of the followings is important information to be observed strictly.
WARNING Failure to follow these instructions properly may result in serious consequences
such as death, severe injury, etc.
CAUTION Failure to follow these instructions properly may cause injury or property damage.
It could have serious consequences depending on the circumstances.
●The following pictograms are used in the text.
Never do.
●Keep this manual at a safe place where you can consult with whenever necessary. Show this manual to installers when
moving or repairing the unit. When the ownership of the unit is transferred, this manual should be given to a new owner.
● Consult your dealer or a professional contractor to install the unit.
● Installation work should be performed properly according to this installation manual.
● Be sure to use accessories and
● Install the unit properly to a place with
If the place is not strong enough, the unit may drop and cause injury.
● Be sure to have the electrical wiring work done by
● Shut OFF the main power source before starting electrical work.
Otherwise, it could result in electric shocks, break-down or malfunction.
● Do not modify the unit.
● Be sure to turn OFF the power circuit breaker before repairing/inspecting the unit.
Repairing/inspecting the unit with the power circuit breaker turned ON could cause electric shocks or injury.
● Do not install the unit in appropriate environment or where
generate,
If the unit is used at places where air contains dense oil mist, steam, organic solvent vapor, corrosive gas (ammonium,
sulfuric compound, acid, etc) or where acidic or alkaline solution, special spray, etc. are used, it could cause electric
● Do not install the unit where water vapor is generated excessively or condensation occurs.
● Do not use the unit in a place where it gets wet, such as laundry room.
● Do not operate the unit with wet hands.
It could cause electric shocks.
②
Preparation before installation (continued)
To change setting
1. Remove the cover by unscrewing two screws from the back of receiver.
2. Change the setting by the switch on PCB.
Cover
Screws
WARNING
in, accumulate or leak.
-
Always follow the instructions given.
parts for installation work.
strength to hold the weight.
electrical installer, and use exclusive circuit.
rioration of its performance or corrosion.
Master/Slave setting when using
395
- plural remote controls
Up to two receiver or
wired remote control can
be installed in one indoor
'19 • PAC-T-327
PJF012D035
PJF012D035
B
B
gas could
1
● Do
● Us
el
● W
m
It
po
Th
co
● Do
● Do
It c
(1
(2
(3
(4
(5
(6
(7
①
Access
Please make
②
Prepara
Setting on s
PCB on the rec
Default setting i
SW1
SW2
SW3
SW4
③
How to
Installation
①
② Put the wi