Option Parts; Wireless Kit - Mitsubishi Heavy Industries FDU45KXE6F-W Technical Manual

12. OPTION PARTS

12. OPTION PARTS
12.1 Wireless kit (RCN-KIT4-E2)
12.1 Wireless kit (RCN-KIT4-E2)
(1) Specification
(1) Specification
Indoor unit terminal block
White
0.3mm2･2-core O.D.φ5.0mm
(Accessory 3m)
CHECK MODE
FILTER
CHECK
Dimensions of ceiling or wall opening
Outline of the receiver
Installation of the receiver
(A) Direct installation onto the ceiling with screws
Wiring
(In case of exposing)
Ｘ Ｙ
Black
REMOTE CONTROL SIGNAL RECEIVING SECTION
Receives a signal from the remote control.
CHECK MODE INDICATOR
When an irregularity occurs, the indicator indicates the status of malfunction by symbol.
ON/
OFF
CHECK
RUN/
TIMER
CHECK
RUN/CHECK LED
The lamp blinks are indicated in 3 patterns as follows.
• Lit up in green : During operation
• Blinked in green : "PREPARATION OF HEATING"
□128
• Blinked in red
TIMER LED (GREEN)
This lamp is lit during the timer operation.
FILTER SIGN LED (RED)
When this lamp is blinked, clean the filter.
Installation method (B)
Installation method (A)
101
108
The following two methods can be used to install the receiver onto a ceiling or a wall.
Select a method according to the installation position.
Wiring
(In case of recessing)
15
32.5
BACK UP SWITCH
When the remote control is missing or defective, this switch can start and stop the
air conditioner.
CHECK SWITCH
This switch is used for maintenance service.
(during heating mode)
: An irregularity occurs in the air conditioner.
Dimensions of the receiver installation
41
33.5
B
36
: (A) Direct installation onto the ceiling with screws
: (B) Installation with enclosed bracket
(B) Installation with enclosed bracket
168
- -
'21 • KX-T-386
PJZ000Z323
PJZ000Z323
These lamps blink when the signal is
received from the remote control.
Each lamp blinks two times in the
order from TIMER to RUN/CHECK
(green) for receiving sign.
46 41
60 34.5
A
B
A
63 29
Wiring
(In case of recessing)
Bracket
(Accessory)