Installation; Preparing Installation; Packing; Completeness And Transport Damage - Siemens 8DJH Series Installation And Operating Instructions Manual

Transport unit
Checking for completeness
Transport damages
500-8067.9 * INSTALLATION AND OPERATING INSTRUCTIONS 8DJH * Revision 03

Installation

11

Preparing installation

11.1

Packing

The transport units can be packed as follows:
• On pallets, covered with PE protective foil
• In a seaworthy crate (switchgear is sealed with desiccant bags in PE foil)
• Other packings in special cases (e.g. latticed crate, cardboard cover for air freight)
ATTENTION!
Packing and consumable materials of the switchgear must be disposed of in an
environmentally compatible way or recycled.
Observe the local regulations for disposal and environmental protection.
On the customer's request, transport units may consist either of:
• Individual switchpanels
or
• Panel blocks with up to four functions
and accessories
11.2

Completeness and transport damage

Check whether the delivery is complete and correct using the delivery notes and
packing lists.
Compare the serial numbers of the switchgear on the delivery note with those on
the packing and the rating plates.
Check whether the accessories included in the subframe are complete.
Temporarily open the packing in a weatherproof place to detect hidden damages.
Do not remove the PE foil until reaching the final mounting position in order to keep
the switchgear as clean as possible.
Check the switchgear for transport damages.
Check the gas density (see Page 97, "Final tests after installation",
Checking the "Ready-for-service indicator").
Refit the packing as far as possible and useful.
Determine and document detected defects and transport damages immediately,
e.g. on freight documents.
As far as possible, document larger defects and transport damages photographically.
Repair or have the transport damages repaired.
Installation
61