I/O Interface - Siemens SIMOTION C 230-2 Operating Instructions Manual

Interfaces

4.8 I/O interface

Note
Use of the drive and encoder interfaces as standard outputs and counter inputs is only possible
via their direct I/O address. Symbolic assignment is not available for this application.
4.8 I/O interface
Front connector
Various encoders and actuators can be connected via digital inputs/outputs to the 40-pin front
connector X1 with single-wire connection.
Position of the connector
The following figure shows the position of the front connector.
Figure 4-13
70
Position of connector X1
Operating Instructions, 11/2022, A5E33441428B
SIMOTION C