Siemens SIMOTION C 230-2 Operating Instructions Manual page 111

Procedure:
1. Insert the PROFINET connector into the drive unit.
2. Open the front door of the C240 PN and insert the PROFINET connector into the X11 P1, X11
P2 or X11 P3 socket.
Note
The strain relief provided for the PROFINET cable must be used in particular for vibrating
machines. The cables should be secured close to the controller to achieve high vibration
strength.
Figure 6-14
Connecting cable
Details about the bus cable, bus connector and installation can be found in chapter Networking
(Page 119).
Note
The maximum cable length is 100 m.
Mixed operation of analog drives and stepper drives (C230-2, C240)
Connecting cables for your configuration are available on request.
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
Strain relief
Connecting
6.1 Wiring
111