Procedure:
1. Insert the Sub-D connector (9-pin) into the drive unit.
2. Open the front door of the SIMOTION C and insert the Sub-D connector (9-pin) into the X8/
X9 socket.
3. Lock the connector using the finger screws. Close the front cover.
Connecting cable
Details about the bus cable, bus connector and installation can be found in chapter Networking
(Page 119).
Note
The maximum cable length is 100 m.
The terminating resistor must be switched in (switch position "On") at the beginning and end of
the bus segment. See figure "Bus connector (6ES7 ...): Terminating resistor connected and
disconnected" in chapter Network components for a PROFIBUS subnet (Page 122)
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
Connecting
6.1 Wiring
109