Siemens SIMOTION C 230-2 Operating Instructions Manual page 118

Connecting
6.1 Wiring
Design of the shield connecting element
The shield connecting element consists of:
• Retaining bracket with two screw bolts to mount the shield connecting element on the
mounting rail (Article No.: 6ES5 390-5AA00-0AA0)
• The shielding terminals
You must use the following shielding terminal, depending on the cable cross-section used:
Table 6-7
2 cables, each with 2 to 6 mm shield diameter
1 cable with 3 to 8 mm shield diameter
1 cable with 4 to 13 mm shield diameter
The shield connecting element is 80 mm wide and provides space for two rows, each with four
shielding terminals.
Fitting the shield connecting element
Fit the shield connecting element as follows:
1. Push the two threaded studs for the retaining bracket into the guide on the underside of the
rail. Position the retaining bracket under the modules to be wired.
2. Screw the retaining bracket tight on the mounting rail.
3. The bottom of the shield connection terminal consists of a web interrupted by a slot. Place
this part of the shielding terminal on edge a of the retaining bracket (see the following
figure). Press the shielding terminals down and pivot them into the required position.
You can fit a maximum of four shield terminals on each of the two rows.
Figure 6-18
118
Assignment of cable cross-sections and shielding terminals
Wire with shield diameter
Fitting the shield connecting element
Shielding terminal
Article No. :
6ES7 390-5AB00-0AA0
6ES7 390-5BA00-0AA0
6ES7 390-5CA00-0AA0
Operating Instructions, 11/2022, A5E33441428B
SIMOTION C