Siemens SIMOTION C 230-2 Operating Instructions Manual page 58

Interfaces
4.6 Onboard measuring system interface (C230-2, C240)
Pin
5
6
7
8
Signal names
Table 4-10
Signal name
A, A_N
B, B_N
Z, Z_N
CLS, CLS_N
DATA, DATA_N
P5EXT
P24EXT
MEXT
Signal type
VO - voltage output (supply)
O - output (5 V signal)
I - input (5 V signal)
Types of encoder that can be connected
Both rotary (shaft encoders, angle measurement systems) and linear (linear encoder, linear
measurement systems) measuring systems can be used. These can be built on the machine/
system (incremental encoder) or integrated in the motor (rotor shaft angle encoder).
58
Encoder
P24EXT
P5EXT
MEXT
Not assigned
Measuring system interface signal names
Meaning
Track A non-inverted and inverted (incremental encoder)
Track B non-inverted and inverted (incremental encoder)
Zero mark non-inverted and inverted (incremental encoder)
SSI clock shift non-inverted and inverted (absolute encoder)
SSI data non-inverted and inverted (absolute encoder)
+5 V supply
+24 V supply
Supply ground
Type Pin
VO 13 B
VO 14 A_N
VO 15 A
Operating Instructions, 11/2022, A5E33441428B
Encoder Type
I
DATA_N I
DATA I
SIMOTION C